Slide the CHIME ON/OFF SWITCH to the crossed-out music note position to turn off the hourly chime and strike. Clocks without Pendulum. Although it is not recommended that you repair your own clock, you should check these items before contacting Howard Miller, your dealer, or an Authorized Service Center. Battery operated howard miller clock manual of style. Otherwise, please follow the instructions below. Damaged Glass Note: Remove all broken glass before packing the clock for return. Using pliers, carefully remove the small nut that holds the minute hand in place by turning. If necessary, adjust hammers so that they do not interfere with each other while moving or striking the chime rods, chime coil or chime bell.
The chime sound will reduce by half of daytime volume for a period of 8 hours. Start pendulum by moving it approximately 1 1/2 inch to the left or right and releasing it. Continue pressing the CHIME SET button repeatedly until the number of strikes matches the current hour. As you remove the chains from the bag, please notice each chain has a hook at the end. Battery operated howard miller clock manual digital. Use a non-silicone liquid or paste wax. This will ensure accurate timekeeping and a consistent chime sound for your enjoyment. After setting it to the correct time, it is important that the clock movement be allowed to operate for at least one hour for the chime sequence to become fully functional.
Through the slot on the end of the pendulum guide, and lower the pendulum until it is. CAUTION: When performing this operation be careful not to scratch the hand nut, hand or dial. While holding the pendulum guide with one hand, slip the pendulum through the front door with your other hand. Contact the Howard Miller web site ( www dot howardmiller dot com) for a list of frequently asked questions that may conveniently resolve your problem or answer your question. Check hammer adjustment and correct chime tone as necessary. Cardboard to secure the movement and chimes during shipping. Return Authorization is required for all returns to Howard Miller.
Hanging securely on the pendulum guide. Weak or exhausted batteries. NOTE: Any time the batteries are removed from the clock, the chime must be reset as described in the HOURLY STRIKE SETTING section. Re-attach the hand to the shaft and turn the hand nut finger tight.
PROCEDURES TO OBTAIN REPAIR SERVICE. 860 East Main Avenue Zeeland, Michigan 49464-1300 www dot howard miller dot com © Copyright Howard Miller Clocks – Mechanical Chiming Wall Clocks and Mantel Clocks © Clocks Blog and 1-800-4CLOCKS. This panel was secured for shipment with retainer clips. The nut counterclockwise while at the same time hold the minute hand with your fingers near the small nut.
Under normal conditions a movement requires oiling with high quality clock oil approximately every two years from the date of purchase. Chime tone may be affected by the hammers resting on the chime rods or striking the rods off center. New moon: moon is not visible. Hang the weights on the pulley. CLOCK DOES NOT STRIKE THE CORRECT HOUR. Place the pendulum hook over the pin or through the slot on the end of the pendulum guide, and lower the pendulum until it is hanging securely on the pendulum guide. Full moon: moon is visible in the center of the dial opening. At the rear of the clock movement are three additional switches and one knob for the following functions: Switch with symbols. WALL AND MANTEL CLOCK. Package the clock into a stiff corrugated carton. Avoid exposing the clock to direct sunlight or high intensity lighting which may fade the finish. NOTE: To perform the following steps, Howard Miller suggests wearing cotton gloves or using a soft cloth when handling parts. While holding the pendulum guide with one hand, slip the pendulum.
Howard Miller Westminster Melody Operating Instructions. If your clock starts chiming erratically, or (if so equipped) the pendulum stops, please install new batteries. Be sure that the pendulum can swing freely. Use the same setting procedure as for "No Moon". FOR ALL CLOCKS – SETTING TIME (moving the hands). When setting the time, the clock will not chime at the 1⁄4, 1⁄2, or 3⁄4 hour positions. If provided on your model, the shipping carton may also include a pendulum and finial that are separately packed. Slide the CHIME ON/OFF switch to the music note position. Adjust as detailed under "Clocks with Pendulum"or "Clocks without Pendulum".
These instructions will provide detailed information to answer most questions. For clocks with a pendulum, cut the rubber band or remove the metal spring clip from. DO NOT ADJUST CHIME HAMMERS, unless the chime tone is incorrect. Step:5 Snug up the hand nut. For example, if the current time is 8:22, press the CHIME SET button until the clock strikes 8 times. Did you wind the clock? By accepting our product for shipment, the carrier acknowledges that the product is in First Class condition. BATTERY REPLACEMENT. Movement W2215: Westminster or Ave Maria, with pendulum. Failure to do so may further damage the clock and would not be covered under warranty. To speed the clock up, move the lever up towards the "+" (plus). Step 2: Carefully remove the small nut. If the hand does not point to the correct mark, repeat steps 2 and 3.
Lift all hammers approximately one inch and then let them return to their resting position. The clock may also chime out of sequence during the first hour of operation. Re-set the time by moving ONLY THE MINUTE HAND backwards as described in the set-up operation. OPERATING INSTRUCTIONS.
CLOCK DOES NOT CHIME AT PROPER TIME. The minute hand has a small raised area on the back side directly around the shaft hole, this is the hand bushing.