The measurement as indicated in the chart. The top side of the unit and the arrow (A, Figure 58) indicates. Slide the drive belt over the edge of the stationary. Turn the adjustment nut (E) until the measurement as. Idler arm is being rotated. Determine the correct spring length for your unit. PRY BELTS OVER PULLEYS. Drive belt ferris belt diagramme. Relieve the tension on the belt exerted from the idler arm. MOWER BELT REPLACEMENT. The square hole located in the end of the idler arm. B. Stationary Idler Pulley. Indicated in the chart is achieved. Idler tensioner spring (B).
Carefully release the tension on. Use extreme caution when rotating the idler. Figure 58 depicts the transmission drive belt setup as seen from. Grooves (Figure 42).
Install the drive belt on the PTO pulley, the spindle. E), the front stationary idler pulley(s) (F), and the adjustable. 5 minutes to break-in the new belt. As a concrete floor. Run the mower under no-load condition for about. Drive belt ferris belt diagram chart. Using a 1/2" breaker bar, place the square end in. Remove the old belt and replace with a new one. Loosen the jam nut (C, Figure 57) on the eye bolt (D). Measure the coil length (A, Figure 57) of the mower belt. Disengage the PTO, engage. Breaker bar, due to the increased tension in the spring as the. Make sure the V-side of the belt runs in the pulley.
Troubleshooting, Adjustment & Service. Idler pulley (G), expect the rear stationary pulley. Clockwise, which will relieve the tension on the belt. The parking brake, turn off the engine, and remove.
Reinstall the mower deck guards. The front of the unit. Pulleys and all idler pulleys except the stationary. Bar clockwise and install the belt on the stationary.
Pulley (B, Figure 41). Lower the mower deck to its lowest cutting. Prematurely released while the spring is under. C. Spring-loaded Idler Pulley.
The eight sided holes (B) (whichever is more convenient to. Arm with the breaker bar, due to the increased. Exerted from the idler arm. Carefully rotate the breaker. To avoid damaging belts, DO NOT.