Social Security Office In Paris Tennessee

Toyota Sienna Sliding Door Won't Open

July 8, 2024, 8:47 am
In this post, we are going to discuss how to fix a broken sliding door. HOW TO GREASE LUBRICATE SLIDING DOORS ON TOYOTA SIENNA. Most common problem is the motor of the latch fails. Problem: The sliding door latch is not working (see the picture of the latch unit). How to repair Toyota Sienna Sliding Door. This way, when you look for used Hiace vans for sale, you will know how to address such problem accordingly.

The door is supposed to unlatch first before it triggers the motor to pull it open. NEW YORK — Toyota is recalling more than 700, 000 Sienna minivans in the U. S. because of problems with the latch that can cause the sliding doors to open while the car is in motion. HOW TO REPLACE/REPAIR SLIDING DOOR CABLE ON A TOYOTA SIENNA 04 05 06 07 08 09 10. The 4th picture shows a closer look at the motor. 2nd Step: Access the Track.

Sounds like the power slider latch assembly or track have gone bad. The label on the motor shows the part number (6th picture). Symptom: When you press a button to automatically open the sliding door it makes noise attempting to open the door but fails. If you are not confident that you can do this on your own, you can bring your HiAce van to an expert mechanic. After getting a new motor, insert the motor back. Keep in mind that they won't work the same as the old ones. They were time consuming, high risk, and more expensive. Step 2: Open the Inside Door Panel. My method is pretty generic, it may apply to other car models. The 5th picture shows the cutout piece of the latch. Generate Transcript. If it only makes some sound without opening the door, then there must be something wrong with the latch. When you get to the guide rails and cables, ensure that they are generously lubricated. I have searched the internet and YouTube to find out how to fix my Toyota Sienna XLE 2006 sliding door problem.

Gently slide a soft cloth over the cable and track. They fit tightly, allowing even the worn pins to grab onto the pipe securely. Obviously, an open sliding door could be a safety hazard. The last step is simply put the cover panel back and you are done. When it gets to the end of the open sequence, it can be closed without any resistance - if that makes sense. However, they are the cost-effective and easy fix for faulty rear rollers. The bad news is you can't just get this part, you need the whole latch assembly which you can get for about $130ish on ebay. Throughout the day, several people slide the door open and close, handling it differently. If it wasn't bad enough that our 2005 XLE had the door weld issue, AND the cable corroding and breaking causing the door not to open NOW on cold days both sliding doors won't open until it warms up ( and not just in the driveway. If I get down close to the bottom of the door near track, I hear a slight metal to metal grinding sound. After lubricating the assembly, try opening and closing the sliding door several times. In the rear of the Hiace van, you will find the tailgate.

Align the flat shaft of the motor and insert it. I finished it in less than one hour the first time, the 2nd time would be even quicker after knowing exactly what to do. After a couple of months of putting off the repair, the battery, which was over three years old, went totally dead. Quick Fix for the Rollers. Can it be replaced by the owner? I saw on YouTube people struggled with removing the latch unit. My method is cheap, about $4 ($6. I got a new replacement battery, and now the door closes properly. Step 3: Replace the Motor of the Latch. Close the sliding doors, then move the track cover about an inch toward the rear.